This will guarantee BI at least one key frame to process. 1 key frame every 4s, then set the pre-trigger buffer (Camera settings -> Record tab) greater than or equal to 4s. See Camera stream optimization article for details.Īlternative fix: If for some reason you cannot adjust the key frame interval on the camera, identify the current key frame interval (Status -> Cameras tab). The detection is working much better now. I would like to also mention that if DeepStack responds back with a prediction that is within the criteria on the first image, it works OK.įix: I just needed to change the keyframe interval to be the same value as the FPS so it is equal to 1.00 (as displayed from Blue Iris). I confirm these images meet the criteria of the minimum confidence percentage and "to confirm". I have confirmed with a packet capture that despite these additional images being sent back to the BlueIris software with a successful response, BlueIris ignores it and goes to cancel the alert. This seems to happen during the second, third or sometimes fourth image that Deepstack analyzes. BlueIris 5.8.0.1 (keep updating to see if it fix itself)Īny ideas or suggestions to fix my BlueIris setup? Thanks!įor some reason, the BlueIris software is ignoring what the Deepstack server says in terms of confidence and the label. contrast 17, min confidence 40 %, reak-time images 4, analyze one each 500ms. I keep increasing the sensitivity with no luck, now: min. I'm using two Reolink 520A cameras, which have had a few issues (the ones in the bottom right corner)The rest of my cameras are some of the cheapest ones I found on Aliexpress, but surprisingly, everything works smoothly with them. However, here's the catch: BlueIris seems to ignore about 60 % of the triggered and confirmed AI detections. The AI is impressively accurate, from what I can tell. It's a bit puzzling, but occasionally, I've noticed that the AI option is grayed out, even though it's clearly doing its job. I've set up one configuration that's synced with all my other cameras, and they all seem to recognize objects just fine with "testing and tuning". Even though the AI shows excellent object recognition at 90 % or more, sometimes it doesn't add the clips to the alerts folder, and I just have no idea that it detected someone without going through the clips and watching it whole. Hey everyone! I recently switched to BlueIris, and I've been loving it so far.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |